How to Pick Out Landing Gear for Trailer, Bulldog or Ultra Fab
Question:
Want to replace landing gear on 2007 desert fox 38u toy hauler. Will either one bolt right up or will I have to modify?
asked by: Steve S
Expert Reply:
In order to pick out a direct replacement for the landing gear on your 2007 Desert Fox 38U we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Bulldog Tandem Landing Gear Set # BD500162. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and then install the brackets of the # BD500162.
I attached a picture that shows the dimensions that this landing gear set would fit with.
The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) is 17-1/2 inches. If this is the case, the landing gear should fit just fine.
If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement.
Products Referenced in This Question
Bulldog Tandem Landing Gear Set - Drop Leg - 36" Lift - 8,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 7001 - 8000 lbs
- Landing Gear
- Sidewind Jack
- 36 Inch Lift
- Bolt-On
- 2 Jacks
- Bulldog
more information >
Product Page this Question was Asked From
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Trailer Wheel for Dexstar Wheel 17-293
- Article: Replacement Automotive Lighting
- Q&A: Replacement Keys and Lock Cores For a Rhino-Rack Zenith Rooftop Cargo Box
- Q&A: How Many Transfer Switches are Needed to Switch from Shore Power to a Genreator, and An Inverter?
- Q&A: Wiring Instructions For The Furrion Automatic Transfer Switch
- Article: How to Charge a Dump Trailer Battery
- Q&A: Solution for Squeaky/Noisy Trailer Suspension with Equa-Flex Equalizers
- Article: Trailer Hitch Receiver Sizes
- Article: Trailer Tire Sizing
- Q&A: No Turn or Brake Signals on Trailer on a Jeep Liberty with Tow Ready Harness 118524
- Q&A: Trailer Grease Seal to Replace 127194TB
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Calculating Portable Generator Power Needs
- Article: Testing Trailer Brake Magnets for Proper Function