Tips for Difficult Pairing of Tekonsha RF Brake Controller

Question:

I fallowed all the steps for pairing but can not get to the point where I can see two zeros. When first installed dealer had same issue but got it to work after a while., any ideas. Thanks

asked by: Anir

Expert Reply:

The issue you are having is not uncommon for German vehicles. There are a few things you can try to get the unit to pair.

First, If you do not see displayed what the instructions say just keep going through the steps. Sometimes, it will not display what it is supposed to but it will still work if you go through the steps to completion.

If that does not work then you can try taping off the pin in the 5 oclock position at the back of the RF (where the trailer plugs into) using electrical tape. Then go through the installation process.

If that doesn't work you may need a 7-Way to 7-Way adapter, # 20142, which will put more load on the system and could allow the RF to pair up properly.

And if all of the above will not work then have a domestic vehicle with a functioning 7-Way parked right next to your vehicle and pair the RF using that vehicle. Then just move the handheld unit to your vehicle and tow the trailer with it and it will work.

expert reply by: Jameson C