How to Know if the Ultra Fab Landing Gear Would Fit a Fifth Wheel Trailer
Question:
Can you please tell me what landing jack i need for a 2005 Rockwood 5th wheel camper. i believe its the 8281SS model
asked by: Kristi R
1
Helpful Expert Reply:
Most of the landing gear sets will use the same bracket height dimensions for the install of a new landing gear set.
Check out the picture I attached that shows the dimensions of the brackets for the Ultra Fab landing gear for you to compare to your trailer.
If the brackets don't line up perfectly the weld stops on your trailer could easily be moved by a qualified welder.
expert reply by:
Jameson C
1
click to enlarge
Product Page this Question was Asked From
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Complete AC System With An Advent 13.5K BTU Low Profile AC Unit
- Q&A: Correct Replacement for Atwood 71119 Landing Gear Motor
- Q&A: Diameter of Replacement Hinge Pin # 362TRCHingePin2
- Q&A: Atwood 87701 landing gear switch replacement
- Q&A: Are Replacement Parts for Atwood Landing Gear Available or Will Another Brand Fit
- Q&A: Recommendation for Replacing Bevel Gears for Atwood Landing Gear or Replacing Entire Landing Gear
- Q&A: What Does Code L. Mean on Curt Triflex Brake Controller
- Article: Best Landing Gear
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How Much Solar Power Do I Need For My RV?
- Article: Does Solar Panel Type Really Matter?
- Article: Trailer Tire Sizing