How Does the Bulldog Square Jack w/ Footplate Install
Question:
How is this jack attached to the trailer.
asked by: Wayne
1
Helpful Expert Reply:
The Bulldog Jack part # BD190754 that you referenced would get welded on for installation.
It can be welded on in various positions and setup, but I attached a picture of what a similar jack would look like welded on.
expert reply by:
Jameson C
1
click to enlarge
click to enlarge
Product Page this Question was Asked From
Bulldog Square Jack w/ Footplate - Drop Leg - Sidewind - 28-1/2" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Magnetek Series 6300A Model 6332 Replacement Converter
- Q&A: Recommended Support Jacks for Rear of Tandem Axle Dump Trailer
- Q&A: Replacement For Fulton Drop-Leg Stabilizer Jack
- Q&A: Replacement Hub for a UFP H-1377 on a 2004 Tahoe Boat Trailer
- Q&A: Inner and Outer Diameters of Pipe Mount Piece for Bulldog Square Swivel Jack w/ Round Pipe Mount
- Q&A: Troubleshooting Factory Trailer Brake Controller On 2011 Ford F-150 Only Working on Manual Override
- Q&A: Recommended Square Bulldog Jack with 5,000 lb Capacity
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: What is Overlanding? How to Start your Overlanding Journey
- Article: Trailer Tire Sizing
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Maintenance Schedule
- Article: Adding Electric Over Hydraulic Disc Brakes