Is Resistor Needed to Install Optronics LED RV Interior Lamp
Question:
Can i hook these directly up to a 12 volt battery system, or do they need a resister? If so do you sell the resister that goes with it?
asked by: Richard
1
Helpful Expert Reply:
The Optronics LED RV Interior lamp you mentioned, part # RVILL33 can indeed be installed directly to 12 volt power. The lamp has two wires, the black wire connects to a 12 volt power source, the white to ground. No resistor is necessary.
Optronics offers a lifetime warranty on the LED's.
expert reply by:
Mike L
1
Product Page this Question was Asked From
Optronics 12V LED RV Dome Light - Single - 6-3/8" Long x 4-3/16" Wide - White Housing
- RV Interior Lights
- Dome Light
- Warm White
- Switch
- Surface Mount
- LED Light
- 12V
- 6-3/8L x 4-3/16W Inch
- White
- Optronics
more information >
Continue Researching
- Article: 2023 Holiday Must Haves
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Hardware Needed to Install etrailer E-Track on Trailer Floor
- Q&A: Do I Have to Have a Sliding 5th Wheel Hitch in a Short Bed Truck
- Q&A: Pulling Breakaway Switch Pin Causes Battery Box to Burn and Melt and Running Lights Stay On
- Q&A: What Do Old Warner Trailer Brake Assemblies Look Like
- Q&A: Can Larger Tire Than 215/60-8 Be Put on Trailer
- Q&A: Trailer Tire Size 215/60-8 vs 205/65-10 on a 2 Place Snowmobile Trailer
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Article: Trailer Wiring Diagrams
- Q&A: Could RV Interior Dome Light part # RVIL21 Work in Motorhome
- Article: Trailer Tire Sizing
- Article: RV Cell Boosters, How Do They Work?
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps