Dimension Where the Wiring Harness Port is on Utility Light part # BUL72CB
Question:
Im looking for full detail specifications for part BUL72CB. it is going into a custom housing and I need to know the location and size of the wire connection to cut a clearance hole.
asked by: Brian
0
Expert Reply:
I went and pulled a part # BUL72CB from our warehouse to get the measurement you requested and found that the wiring harness port starts at 1 inch from the end of the light closest to it and is 1/2 inch wide.
I attached a picture to help explain.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Optronics LED Trailer Utility Light - Submersible - 10 Diodes - Oval - Clear Lens
- Work Lights
- Utility Lights
- Exterior Lights
- Interior Lights
- Oval
- Recessed Mount
- LED Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Grease Seal Recommendation to Replace TCM 21334
- Article: Trailer Wiring Diagrams
- Q&A: Finding The Correct Replacement Bearings And Seals For A Bix Tex Trailer With 5,000 lb Axles
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Motor For Power Gear Part 1510000006 On 2006 Fleetwood Fista
- Q&A: Flat Towing Components And Requirements For A 2024 Chevy Equinox
- Q&A: How to Cut a Grommet Hole for Installation of the Oval Trailer Tail Lights # STL22RB
- Q&A: Recommended 6 Inch Oval LED Backup Light For Brightness
- Q&A: Recommended Replacement for 25-1/4 Leaf Spring for 3,500 Lb Axle
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Best RV Roof Vents
- Article: How to Replace an RV Roof Vent Cover
- Article: Performance Chips and Modules