Troubleshooting Trailer Wiring that Doesnt Function After Install on 1987 Nissan Truck
Question:
I purchased a wiring kit for my 1987 Nissan pickup and removed the driver sidw rear tail light grounded white wire mounted the converter and pluged wires in ran green wire across to other side and pluged in I only have tail lights on trailer no turn signal left or right or brake either what did do wrong?
asked by: Arnett S
Expert Reply:
First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part # PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached.
If the voltage checks out there but the trailer lights still don't function right then the problem is on the trailer wiring. That would mean that problem is either due to a ground issue or a short issue.
Make sure that the trailer side connector is clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
If the problem is on the vehicle side then I would first recommend you double check how the harness is installed on your vehicle, make sure all of the connections are good and tight. You should check all towing related fuses and relays as well.
Products Referenced in This Question
Product Page this Question was Asked From
4-Way Flat Trailer Connector w/ 60" Harness and Wire Taps
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Tekonsha
more information >
Continue Researching
- Q&A: Can Hitch Ball Size Be Changed Out on Curt Euro Style Ball Mount
- Q&A: Does Valterra Wheel Chock Have a Weight Capacity
- Q&A: Installing a 4-Pole Trailer Connector at Rear of 5th Wheel for Towing Boat Trailer
- Q&A: How to Add 4-Way to the Back of Camper Trailer for Towing Second Vehicle
- Q&A: How to Wire a Stop/Turn/Tail Trailer Light With Two Wires to a Trailer
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Most Popular Wheel Bearings
- Article: Flat Towing Package for 2002-2004 Jeep Liberty
- Q&A: Installing 4-Pole Trailer Connector on 2002 Chevy Silverado with No Trailer Connector
- Q&A: How to Find Replacement for TDE 11029C Hub Assembly
- Article: How to Measure for Trailer Hitch Drop