How Snug Should Pro Series Adjustable-Channel Coupler Fit Inside Mounting Channel
Question:
I have a trailer with this coupler installed but it does not fig snuggly into the channel. Is it supposed to have some up and down play or is it to be a tight rigid fit?
asked by: Tony
0
Expert Reply:
When you have the Pro Series Adjustable-Channel Coupler, part # PSA256S0303 installed it should not have any play on the channel. This coupler is designed for a 2-7/8 inch channel.
I called my contact at Pro Series and they told me that if needed you can place a washer between the coupler and the inside flange of the channel if needed.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Pro Series Adjustable-Channel Coupler w/ Low Latch - 2-5/16" Ball - 14,000 lbs
- Adjustable Trailer Coupler
- Coupler Only
- 14000 lbs GTW
- 2-5/16 Inch Ball Coupler
- Thumb Latch
- Pro Series
more information >
Continue Researching
- Shop: Curt Channel-Mount Coupler - Squeeze Latch - 2-5/16" Ball - 15,000 lbs
- Article: Most Popular Wheel Bearings
- Q&A: Are Oblong Holes Okay on Weight Distribution System Part 54970
- Article: Trailer Tire Sizing
- Q&A: Replacement Trailer Tires for Size F78-14 Tires on a Boat Trailer
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Difference Between Single, Dual and Free Backing Servo Brake Assemblies
- Q&A: Removal and Installation of a Unitized Oil Seal for a Trailer Oil Bath Hub
- Q&A: Does Pro Series Coupler # PSA256S0303 Fit Titan Channel Bracket # T4865900
- Q&A: Advantage of Double Lip Grease Seals Versus Single Lip
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: How Strong Are The Magnets On The Optronics Magnetic LED Tow Light Kit?
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Wiring Diagrams
- Article: Where to Position the Trailer Axle?