Can the Ramp Spring # RS16933LH Be Installed on a 1-1/4 inch Diameter Pin
Question:
My equipment trailer has 1 and a quarter inch ramp hinge shaft diameter and I was wondering if I could still use the 1 and a half inch spring on it.?
asked by: Jay
0
Expert Reply:
The inner diameter of the Ramp Spring # RS16933LH that you referenced is 1-1/2 inches, you could easily use this spring on a hinge shaft that is 1-1/4 inches in diameter.
I spoke with my contact at Redline to confirm this.
expert reply by:
Jameson C
0
Products Referenced in This Question
Ramp Spring - 2K Torque for 1-1/2" Round Shaft - LH
- Trailer Ramp Springs
- Single Ramp Spring
- Left Hand Spring
- 11 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Product Page this Question was Asked From
1/2" Diameter Greasable Hinge Pin, 4-1/2" Long
- Trailer Door Hinges
- Hinge Pin
- Build Your Own Hinge
- Greasable Pin
- 4-1/2 Inch Long
- 1/2 Inch Diameter
- Weld-On
- Redline
more information >
Continue Researching
- Q&A: Determining The Correct Replacement Suspension Components For A Single Axle Trailer
- Article: Trailer Wiring Diagrams
- Article: Overview of Lubricating Grease
- Q&A: Does Karrier ST225/75R15 Radial Trailer Tire with Wheel Use Acorn or Ball Lug Nuts
- Q&A: Overall Dimensions of the Hangers in Single-Axle Trailer Hanger Kit APS1
- Q&A: Single Axle Hanger Spacing Recommendation for a Leaf Spring # e54SR and Hanger Kit # APS3
- Q&A: Differences in the Redline Single-Axle Trailer Hanger Kits, # APS1, #APS2, and # APS3
- Q&A: Comparing the Single-Axle Trailer Hanger Kits for Double-Eye Springs APS1, APS2, and APS3
- Q&A: Recommended Hanger Kit for Single Axle Double Eye Leaf Spring Trailer Suspension
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Most Popular Wheel Bearings
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub