Troubleshooting Trailer Taillights Where None Work
Question:
Just wired my trailer and no lights anywhere hooked my tailgate light up and that works?
asked by: Ryan
Expert Reply:
So the problem is on your trailer then if the trailer wiring harness works to light up your tailgate lights.
Make sure that the trailer side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
Product Page this Question was Asked From
Adapter 7-Pole to 4-Pole and 5-Pole
- Trailer Wiring
- Wiring Adapters
- Multi-Function Adapter
- 7 Round - Blade
- Plug Only
- 4 Flat
- 5 Flat
- Hopkins
more information >
Continue Researching
- Q&A: Does the Tekonsha P3 Trailer Brake Controller Turn Off or Stay On All the Time
- Q&A: Recommended Hitch for a 2024 Mazda CX-90
- Q&A: Why Does My Brake Controller Light Stay On After Vehicle is Turned Off
- Article: Trailer Wiring Diagrams
- Q&A: Replacement 4-Pin Plug For Truck Camper
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Possible Light Replacement For Monarch 5129 On 1977 Great Divide Trailer
- Q&A: Draw-Tite DT78MR vs 76104 That Fits 2021 Jeep Wrangler
- Q&A: Recommended Trailer Connector And Wiring Harness For 2014 Jeep Wrangler Unlimited With Tow Package
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Best Camper Jacks
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Raise Your Travel Trailer Height