Replacement Plunger Pin Recommendation for Bulldog Landing Gear
Question:
I was hoping you had an older jack plunger pin assembly that has a spring clip through which a pin slides through a bracket welded to the jack and then through the plunger pin. The welded bracket, spring slip and pin that goes through the plunger pin the plunger pin in place, allowing it to pull out of a slot in the jack and slide back into the next slot as the jack pumps up or down.
asked by: Sanat S
Expert Reply:
It sounds like you are looking for a replacement plunger pin kit for the landing gear on your trailer so that the inner tube of the landing gear can easily be raised or lowered. If the landing gear you have happens to be by the brand Bulldog you would want the part # BD500103.
Here are some specs for you to compare to what you have on your trailer:
Pin diameter: 3/8"
Length of pin: 4-1/4"
Hole center to short end of pin: 7/8"
Straight portion of pin: 2-3/8"
