Finding Brake Light Wire On 2011 Volkswagen Golf When Installing Brake Controller
Question:
I am attempting to install a Tekonsha Prodigy brake controller on my 2011 VW Golf. I removed the Prodigy from my older Jetta, but it never did work correctly on the output of the Curt trailer light converter as a signal to the controller. I have searched your web site and cannot find any specific instructions for locating a suitable wire in the absence of an older US-type brake light switch. Although one post said it could be done, your tech adviser did not identify a connection point to tap. The light switch on the VW Golf master cylinder feeds to the power-supply control unitinch computer which then that sends signal to the brake lights, according to the British version of the Haynes Workshop manual. It also sends, on the same wire, voltage to the engine management computerinch so I am afraid to tap that circuit. Can you advise me on a suitable tapping point in the Golf for the brake controller red wire designed for the cold side of the brake light switch? Thanks
asked by: Jack A
Expert Reply:
Some vehicles do make it tough to simply wire into the brake light switch for the brake controller and your Golf may be one of those, but I do have a solution for you.
I called my contact at Tekonsha and they told me that you will want to find the wire that leads to the third brake light. Use a tester like part # PTW2993 and find the wire that only shows power when the brake pedal is pressed. You would then attach the red wire from the brake controller to that wire.
Although they were unable to tell me which side of the vehicle the wire is run, you will typically find the wire under the door threshold on the driver or passenger side.
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Parts Needed to Flat Tow 2023 Jeep Gladiator
- Q&A: No Splice Tow Bar Lighting Kit Recommendation for 2024 Jeep Wrangler
- Q&A: Troubleshooting Lack of 12V Power at 7-Way Trailer Connector on 2019 Ford F-150