Do Factory Bump Stops Get Trimmed to Install AirLift Air Bags on a 2004 Chevy Venture
Question:
I have a 2004 Chevy venture 2 wheel drive do you have to remove the bumps stops on the top of the springs or cut them or just leave in place. Do I have to remove the springs or just squeeze them inlace when you the suspension on a jack
asked by: Angelo.
0
Expert Reply:
When installing AirLift 1000 system # AL60748 you will need to cut off the bottom 2 sections of the factory bump stops on your 2004 Chevy Venture. There would not be enough room otherwise. I have included a link to the installation instructions for you to view as well.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Air Springs
- Light Duty
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Trailer Axle Kit for Fabricating Off-Road Utility Trailer
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: How to Determine if my Trailer Has Electric or Hydraulic Brakes
- Q&A: Estimated Installation Time for Firestone Ride-Rite Air Helper Spring Kit F2550