Why Would a Small Spring End Up Lodged in a Trailer Bearing
Question:
I have a pop-up camper with a 1-3/4inch 2000# axle and 1inch spindles. When I pulled the bearings to clean and re-pack, I noticed a tiny coil spring embedded on the inner bearing, between the bearing and seal cap. They were damaged during cleaning. What is the purpose of these, and since they are damaged should I order this new kit BK1-100? Thanks!
asked by: Jon
Helpful Expert Reply:
On double lip trailer hub seals there is a small spring that is designed to hold the seal tight to the spindle. It sounds like that spring made its way off of the seal and into your bearing.
Your best option would be to replace the bearings and seals. If the # BK1-100 has the bearings and seals that you would need this would be the correct kit. It comes with inner/outer bearings L44643 and a seal that has an inner diameter of 1.249.
The bearings are both designed to fit a spindle that is 1 inch in diameter.
Product Page this Question was Asked From
Bearing Kit for 1" BT8 Spindle, L44643 Inner/Outer Bearings, 34823 Seal
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- Bearing Kits
- Bearing L44643
- Race L44610
- 2000 lbs Axle
- 2500 lbs Axle
- etrailer
more information >
Continue Researching
- Shop: Dexter Nev-R-Adjust Electric Trailer Brakes - 12" - Left/Right Hand Assemblies - 6K
- Shop: Bearing Kit, LM67048/25580 Bearings, 10-36 Seal
- Shop: Bearing Kit, LM67048/25580 Bearings, GS-2125DL Seal
- Shop: Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2
- Shop: Kenda Karrier ST205/75R14 Radial Trailer Tire with 14" Black Mod Wheel - 5 on 4-1/2 - LR C
- Shop: Grease Seals 10-36 (pair)
- Shop: Replacement Trailer Hub Bearing - LM67048
- Q&A: Replacement 12" Dexter Electric Brakes for 5,200 Pound Trailer Axle
- Video: Dexter Axle Trailer Hubs and Drums - Hub with Integrated Drum - K08-426-91 Review
- Q&A: Replacement Wheel Stud For Dexter Hub and Drum Assembly K08-426-91
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Is Silicone Sealant Required When Installing New Seal on Trailer Hub
- Search Results: 01001900
- Video: Loctite Silicone Gasket Maker Review
- Video: Review of Timken Trailer Bearings Races - L44649 and L44610 Set - TMK23VR
- Search Results: entry door
- Search Results: rv entry door lock
- Q&A: Determining the Appropriate Bearing Buddy Size Using Bearing Part Numbers and Existing Measurements
- Video: Bearing Repacking and Grease Seals Installation
- Search Results: 010~019~00
- Search Results: dexter 010 019 00
- Video: Bearing Buddy Trailer Bearings Races Seals Caps - Seals - BB60011 Review
- Q&A: Replacement Grease Seal 225255UC for 2015 Wesco Trailer
- Search Results: ad2527e grease seal
- Search Results: bk2~100
- Q&A: My Axle Has No Cotter Pin Hole Can I Install Bearing Kit for #84 Spindle?
- Q&A: Method for removing and Installing Tang-Style Spindles Washers
- Shop: Roof Rack
- Video: Review of Performance Tool Jumper Cables and Starters - 16 Foot Long 6 Gauge Jumper Cables - PT34NJ
- Video: Review of etrailer Trailer Hubs and Drums - Pre Greased Hub with Integrated Drum - AKHD-555-35-K