Does Stromberg Carlson Camper Jack # JSC-24 Use Stamped Construction
Question:
Is the cog teeth on the Stromberg Carlson scissor jack, JSC-24, stamp formed or is it two sheets of metal welded flat to form the cog?
asked by: Michael A
0
Expert Reply:
The Stromberg Carlson Camper Jack # JSC-24 uses a solid nut to engage the threaded shaft that lifts the jack. The main structure of the jack is stamp-formed.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Leveling Scissor Jack Set - 24" Lift - 10,000 lbs - QTY 2
- Camper Jacks
- Fifth Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 9001 - 10000 lbs
- Scissor Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 2 Jacks
- Stromberg Carlson
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Mounting Tab and Hole Size and Spacing of Ultra-Fab # UF48-979006 Scissor Jack
- Q&A: Does 15" Americana Aluminum Mod Trailer Wheel Have a Max PSI Rating
- Q&A: Replacement Landing Gear for a Keystone Laredo 5th Wheel Trailer
- Q&A: Replacement Landing Gear Parts for 2009 Keystone Laredo 265RL 5th Wheel
- Q&A: Can ARK Stabilizer Jacks Rotate 180 Degrees
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Stabilizer Jacks for 2020 Rpod 195
- Q&A: Scissor Jack Recommendation to Replaced Damaged Ones on R Pod Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: How to Choose the Right Trailer Hitch Class