Dimensions Between Mounting Holes for Door Plunger and Socket
Question:
On the PLR64-66 Door plunger and socket What is the on center distance between the mounting holes for each piece? Thank You
asked by: Steve
0
Expert Reply:
I went out to the warehouse and pulled the # PLR64-66 and took some measurements for you. The dimensions from center to center of the mounting holes on the plunger is 2 inches and on the socket it is 2 inches center to center.
I also made an image of the part showing these measurements for your reference and attached a product demonstration video too.
expert reply by:
Chris O
0
click to enlarge
Product Page this Question was Asked From
Plunger and Socket Trailer Door Holder - 2-1/4" Plunger - Zinc Plated Steel
- Trailer Door Holders
- Plunger and Socket
- 2-1/4 Inch Plunger
- 2 Inch Hole Spacing
- Rubber
- Polar Hardware
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can 10" Electric Brakes go on 2,200 lb Axle
- Q&A: Upgrading Axles from 2,200 lbs to 3,500 lbs to Utilize 10 Inch Electric Brake Assemblies
- Article: Best RV Roof Vents
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Hub for Older Dexter 8-245
- Q&A: What is the Best Grease for Trailer Bearings
- Article: Stability Control for Heavy Duty Vehicles
- Article: RV Propane 101: How Does My RV's Propane System Work?
- Q&A: How to Wire a 7-Way Trailer Connector on a 2015 Chevrolet Silverado 1500
- Q&A: How To Attach The Hullavator Pro Kayak Carrier To The Roof Of A 2015 Toyota 4Runner
- Q&A: Recommended Electric Winch for Raising and Lowering a Pop Up Camper
- Article: The 5 Best Trailer Drop Hitches You Can Buy