Installing Brake Controller Wiring Adapter Part # 3035P on 2004 Ford Expedition
Question:
2004 ford expedition cannot find the plug that is shown on how to for Factory Installed 4-Way labeled picture B. my 4-way pin does have an extra wire taped up but not connected by the 4-way . need to know if there is actually a plug as in picture . Then I will Know what to order. Thanks
asked by: Michael m
Expert Reply:
The connection point for the brake controller should be located under the dash just above where where your right leg would be if you were behind the wheel.
I have an installation video that shows the location of the connector. The video shows an install on a 2007 Expedition, but the procedure would be similar on your 2004 model. The connector you are looking for is gray in color.
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford, Lincoln, Mercury
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Recommended Replacement Brakes for a 2007 Pace Trailer w/ 15 Inch Rims
- Article: Brake Controller Installation: Starting from Scratch
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Bulldog Powered-Drive Kit Compatibility With 12K Ram Landing Gear
- Q&A: Best Brake Controller for a 2014 Fleetwood Bounder Motorhome
- Q&A: Location of Brake Controller Wiring Connector on 2014 Fleetwood Bounder on Ford F-53 Chassis
- Q&A: Brake Controller Recommendation for a 2021 Ford F-53 with Brake Controller Harness
- Q&A: Can Trailer Brakes Be Manually Applied with Tow-Pro RED24FR Liberty Brake Controller
- Q&A: Replacement AC Unit for Dometic Duo-Therm Air Conditioner 630516.331 on 2008 Four Wind Siesta
Mike L.
5/24/2010
The connection point for the brake controller should be located under the dash just above where where your right leg would be if you were behind the wheel. I have an installation video that shows the location of the connector. The video shows an install on a 2007 Expedition, but the procedure would be similar on your 2004 model. The connector you are looking for is gray in color.