Troubleshooting Trailer Taillights that Flicker and Turn Signals Dont Work
Question:
I recently purchased a wiring harness through your site. It does not work properly. I would like to know what my options are? My situation is that mY trailer lights flicker and dont work properly. The turn signals dont work and the lights just stay on all the time they are plugged in. My ground is good. I did buy the 4 pole to 5 pole connection too but I dont think that is causing the problem. Please advise.
asked by: Ryan C
Expert Reply:
First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part # PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached.
If the voltage checks out there but the trailer lights still don't function right then the problem is on the trailer wiring. That would mean that problem is either due to a ground issue or a short issue.
Make sure that the trailer side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
If the problem is on the vehicle side then I would first recommend you double check how the harness is installed on your vehicle, make sure all of the connections are good and tight. You should check all towing related fuses and relays as well. What you described can sometimes be due to the converter box shorting out.
What you will want to do is test the wires going into the box of the converter box for voltage with a circuit tester like the # 3808 to see if there is voltage going into the box when the taillight functions of your vehicle are applied, and then test the output side of the box to see if the current is making it through the converter. If not then the problem is that the converter box has shorted itself out and would need to be replaced.
Before you replace it you will want to inspect the wiring of your trailer to see if you can find anything that would cause the box to short out like corrosion or cut/exposed wiring. These boxes don't usually go out unless there is a short on the trailer that takes it out.
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: All Parts Needed to Flat Tow 2014 Chevy Silverado 1500 Behind Motorhome
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: How to Test Brake Controller without Trailer Connected
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Recommended Flat Towing Parts for a 2024 GMC Canyon Denali
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Troubleshooting Lack of 12V Power at 7-Way Trailer Connector on 2019 Ford F-150