Trailer Hitch with Best Ground Clearance and Trailer Wiring for a 2015 Honda Odyssey
Question:
I need to get a set up to tow my boat. I have a 2015 odyssey. Which hitch will give me the most ground clearance after it is installed and does the hitch from honda give more ground clearance? Thank you.
asked by: Nathan
Expert Reply:
In terms of ground clearance, the Class II hitches for your 2015 Honda Odyssey will have slightly better clearance than the Class III hitches. From the ground up to the bottom of the receiver it will be approximately 9-1/2 inches. This isn't much but vans sit low to the ground so it is to be expected.
As far as the factory hitch It is probably in a comparable position but it is possible that it is slightly higher or lower.
For a trailer hitch you can use # 36417. This hitch is rated for 300 pounds tongue weight and 3,500 pounds gross trailer weight. The proper ball mount for it is # 36071. For a 1-7/8 inch ball you can use # 19256 and for a 2 inch use # 19258.
And for a trailer wiring harness you can use # 118521. I have linked videos showing how the hitch and wiring install.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
1-7/8" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 2,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 1-7/8 Inch Diameter Ball
- 1-9/16 Inch Shank Length
- 3/4 Inch Diameter Shank
- 2000 lbs GTW
- Class I
- Class II
- Draw-Tite
more information >
2" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 3,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 1-9/16 Inch Shank Length
- 3/4 Inch Diameter Shank
- 3500 lbs GTW
- Class I
- Class II
- Draw-Tite
more information >
Drawbar for 1-1/4" Hitch - 2-5/8" Rise, 3-1/4" Drop - 7-3/16" Long - 3.5K
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 3 Inch
- Rise - 2 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- Class II
- Draw-Tite
more information >