Radial Orientation of Eye Bolts on E-Z Flex Heavy Duty Rubber Suspension System
Question:
in the directions to the ez flex there is no illustration regarding reassembly of axle suspension, where in the caution section its says note the specific radial orientation of the grease holes......... Which way are they supposed to go?
asked by: Jim
0
Expert Reply:
I spoke with my contact at Dexter regarding E-Z Flex Heavy Duty Rubber Suspension System equalizers # K71-652-00 and she said the orientation of the zerk fittings should be horizontal or 3 to 9 o'clock position.
expert reply by:
Chris O
0
Product Page this Question was Asked From
Dexter E-Z Flex Suspension Kit - Double-Eye Springs - Tandem Axle - 6,000 lbs
- Trailer Suspension Parts
- Equalizer Upgrade Kit
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 5-5/8 Inch Long
- Tandem Axle
- Dexter
more information >
Continue Researching
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Can Hydraulic Brakes of Demco Tow Dolly be Converted to Electric Brakes
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Q&A: Installation Information for the Replacement Cables for Enclosed Trailer Ramp Spring # ERS160D96
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Harvest Hosts
- Article: What To Look For When Buying Ratchet Straps
- Article: Where to Position the Trailer Axle?
- Article: Must Have RV Accessories that Will Make or Break Your Trip