Can the Hopkins Backup Camera part # HM50002 be Installed on a Vehicle with 4-Way
Question:
I like the Hopkins camera system that was emailed to me. I watched the video and noted that it was for a 7 pin connector. I have an after market trailer system using the standard 4 pin connector. Do you have a model that has the 4 pin setup?
asked by: R. B
0
Expert Reply:
The Hopkins Backup Camera part # HM50002 that you referenced can be installed on a vehicle that does not have a 7-way on it like yours. You will need to tap into the reverse light circuit like the video I attached shows.
Your 4-way would not be needed in any way for the install.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Hopkins Smart Hitch Backup Camera and Hitch Aligner System
- Backup Camera
- Hitch Alignment Camera Systems
- Hardwired
- Dash Monitor
- 3.5 Inch Display
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: My Firestone Compressor Keeps Running Even When Air Bags Are Full
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Size Wire Gauge is Used in Vision X 9007 Halogen Headlight Bulbs with Relay Harness
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Parts Needed to Swap a Trailer With Surge Brakes to Electric Brakes
- Q&A: Parts Needed To Install Trailer Brake Controller For a 2006 Toyota Tundra With Factory 7-Way
- Q&A: 2018 Ram 1500 Firestone Ride Rite Air Bag Kit Recommendation
- Article: Performance Chips and Modules
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Wiring Diagrams
- Q&A: Tank Size for Air Lift WirelessAIR Suspension System for Air Helper Springs
- Q&A: Do the Firestone Airbags for a 2024 Ford F-350 Fit the Dually Models?