How Many Install Brackets Per Bar are Used on the Westin E-Series Nerf Bars 23-3710
Question:
how many degree bend both end? andhow many bracket?
asked by: Chris
0
Expert Reply:
The bends on the ends of the Westin E-Series Nerf Bars are basically 90 degrees as they turn in and face the vehicle.
The bars use 3 brackets per side. Check out the picture I attached to see a similar bar that uses the same install brackets. You will notice that the bars do no bend in 90 degrees in the picture, that is only because these install instructions (also attached), are for several different bar styles that use the same install brackets.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Westin E-Series Round Nerf Bars - 3" - Polished Stainless Steel
- Nerf Bars - Running Boards
- Nerf Bars
- Round
- 3 Inch Wide
- Cab Length
- Polished Finish
- Fixed Step
- Stainless Steel
- Silver
- Westin
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Will DeeZee Nerf Bars DZ372531 For Both Crew and Double Cab 2017 Chevy Silverado 1500
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Does HBA-CAM Adapter Module for Hydrastar Electric Over Hydraulic Brake Actuators have 2 or 4 Wires
- Article: Trailer Tire Sizing
- Q&A: Can Hydraulic Brakes of Demco Tow Dolly be Converted to Electric Brakes
- Q&A: Adding Brakes to a Mobile Home Axle
- Article: Brake Controller Installation: Starting from Scratch
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer