Can an A-Frame Jack be Rotated on the Trailer for Hatch Clearance
Question:
I own a Dodge Durango and I cant open my rear hatch, it hits the motor housing on the jack. is it possible to rotate the housing 90 degrees? Thanks
asked by: Bob B
1
Helpful Expert Reply:
You can rotate an A-frame jack like the Stomberg Carlson Jack part # JET-3555 that you referenced if needed to allow you to open your rear hatch. The bolt pattern of the jack is allows for mounting of the jack in any orientation.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 24" Lift - 3,500 lbs - White
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Recommended Replacement Jack For Lippert Smart Jack With Damaged Buttons Causing Water To Get In
- Q&A: Best Solution For Gaining Tail Gate Clearance On A-Frame Trailer Tongue Jack
- Q&A: What is the Distance from the Mounting Surface to the Top of Electric Trailer Jack # JET-3555
- Q&A: Fuse Location for 12-Volt Accessory Feed to 7-Way Trailer Connector on 2005 Chevy Silverado
- Q&A: Retracted Height of Stromberg Carlson Electric A-Frame Trailer Jack JET-3555
- Q&A: Quieter RV Water Pump Recommendation
- Q&A: Trailer Jacks Manufactured in the USA
- Article: Best Camper Jacks
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Jacks
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: What is an RV-Approved Bike Rack? (And Do You REALLY Need One?)