Timbren Helper Spring Recommendation for a 2002 Ford Windstar
Question:
Hello, I recently purchased the Timbren suspension assist system and just started to install. But the basic installation instructions do not seem to match how my vehicles existing suspension is set up. The instructions state to remove existing axle bumps. The only way I can see to do this is tear them off. I also do not see any place to mount the Timbren assembly without an additional bracket of sorts. Are there more detailed instructions available? My vehicle info: 2002 Ford Windstar SEL 3.8L thank you
asked by: Robert V
Expert Reply:
The Timbren system part # TFRWIN that you referenced has been confirmed as a fit for your 2002 Ford Windstar.
On the axle where the old bump stop was located there will be a plate that has a bolt hole that the mounting bracket of the # TFRWIN will install into. There should be a bolt that secures the current bump stop and bracket to the axle that would need to get removed.
Product Page this Question was Asked From
Timbren Rear Suspension Enhancement System
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Jounce-Style Springs
- Standard Duty
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Troubleshooting Timbren Spring # TDVRRT Noise on 2012 Dodge Grand Caravan
- Q&A: 2012 Dodge Caravan With Failed Airbags Troubleshooting
- Q&A: Wiring Side Marker Lights on Trailer as Turn Signals
- Q&A: Getting Side Marker Lights to Function as Turn Signals and Running Lights
- Q&A: Converter Needed for Side Clearance Lights of Trailer Lighting to be Turn Signals
- Q&A: Recommended Hitch and Ball Mount for a 2023 Kia Telluride
- Q&A: Can The SumoSprings Trailer Helper Springs # SS26MV Be Used On a 2019 Grand Design Solitude?
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Best Air Bag Suspension (2023)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)