Installing Draw-Tite Brake Controller On 2005 Chevrolet Silverado

Question:

i was given a drawtite 5500.the plug ins have been cut off.can i get instructions for hard wiring from you? 2005 silverado.thank you.

asked by: Bob

Helpful Expert Reply:

I recommend using part # 3015-P to easily install the brake controller. You just cut off the black connector on the adapter and wire it to the matching colors at the back of the brake controller. The other end of the harness plugs into the junction box located under the dash to the left of the brake.

I have also attached some helpful articles that explain brake controller installation and troubleshooting you can check out.

expert reply by: Jeffrey L