Is the Trailer Identification LED Light Bar # MCL84RB Submersible
Question:
Hi Everyone! Are these submersible for a boat trailer application? Thanks!
asked by: Hal
0
Expert Reply:
The Sealed, 3-Light Truck, Trailer Identification LED Light Bar # MCL84RB that you referenced is submersible, but we still recommend you unplug your trailer lights when backing your trailer down the boat ramp so as to prevent any shorts due to the trailer's wiring.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
LED Identification Light Bar for Trailers over 80" Wide - Submersible - 9 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- ID Bar
- Surface Mount
- Submersible Lights
- LED Light
- 17L x 1-1/2W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Grease Seal to Replace Part Number 174253tb
- Q&A: Picking Out Replacement Grease Seal for # 174253TB
- Q&A: Is Tire Size 20.5 x 8-10 the Same as a 205/65-10 Trailer Tire
- Q&A: Replacement Cushioned Pin Box for a Leland 7920
- Article: Trailer Wiring Diagrams
- Q&A: Warranty of Tekonsha Activator IV Trailer Brake Controller
- Q&A: How To Install the Spindle Nut on a 12,000 Pound Dexter Axle
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Maintenance Schedule