Hitch Recommendation for the 2002 Mercedes Benz C-Class

Question

Question:

I have a 2002 Mercedes C230 Kompressor, do you have a trailer hitch for it? You list a hitch for the sedan, this is the hatchback, also called the C230 KM.

asked by: James B

0

Expert Reply:

For your 2002 Mercedes Benz C-Class we do offer the Curt Hitch part # C11824. This fits the sedan models like you referenced as well as the wagon models which it sounds like you have.

Check out the install video I attached for this hitch as well.

expert reply by: Jameson C

0

Answer 1

We do indeed have a Class I hitch available for your 2003 Mercedes C240 Wagon, part #C11824. If you'll be using the hitch for light duty towing purposes, the hitch has a 2500 lb towing/ 250 lb tongue weight capacity. You'll want to check with…

view full answer...

Answer 2

Curt has not done a test fit on the rather rare Sedan model of the 2003 Mercedes-Benz C Class. My Curt representative's build drawings did not have the exact measurement you were looking for, but the outside of the front plate to the hole center…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 8

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 9

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 10

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 11

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Hitch Recommendation for the 2002 Mercedes Benz C-Class

Featured Help Information

Miscellaneous Media

Continue Researching