Does the Bump Stop of a 2011 Toyota Tacoma Get Removed to Install Timbrens
Question:
Im thinking of installing a timbren rear system on my 2011 Toyota Tacoma. There is already a hard solid rubber thing on both sides attached to the axle/u-bolt where the two air bags would go. will this have to be removed ? I can send a picture if need be
asked by: Bo R
0
Expert Reply:
What you have found on your 2011 Toyota Tacoma is the bump stop, or jounce bumper. This will get removed to install the Timben part # TTORTUN4 that has been confirmed as a fit for your 2011 Toyota Tacoma.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Timbren Rear Suspension Enhancement System
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Jounce-Style Springs
- Extra Heavy Duty
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Best Way to Prevent Sagging Suspension When Towing a Trailer
- Q&A: Height of the Rubber Spring of the Timbren kit part # TTORTUN4 and # TORTUN4L
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Q&A: Recommended Suspension Enhancement System for a 2023 Ford F-150 Raptor
- Q&A: Selecting The Correct Cushioned Equalizer and Wet Bolt Kit For a Grand Design 2800BH
- Article: Determining Trailer Tongue Weight
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Recommended Spare Tire for Cargomate Trailer with 15 Inch Wheels
- Q&A: Overall Height of Timbren Suspension Enhancement Springs # TTORTUN4 for a 2010 Toyota Tacoma
- Q&A: Fit & Height of Timbren Suspension Enhancement on 2019 Toyota Tacoma 4WD
- Article: Trailer Wiring Diagrams
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: My Trailer Hitch Doesn't Fit