How to Install a Brake Controller in a 2013 Toyota Tundra with Factory 7-Way

Question:

I have 2013 Toyota tundra and plan to purchase 39523 for 2 axle camper. Im not sure what I need to wire it. I have a factory plug near the parking break. Does this controller come with long enough wire to reach the console? Do I need an accessory cord? How do I know if the controller plug is the same as factory plug?

asked by: Adam

Expert Reply:

To install the Tekonsha PowerTrac Brake Controller part # 39523 in your 2013 Toyota Tundra with a factory 7-way all you need is the correct install harness, part # 3040-P. This plugs into the connector found near your parking brake.

To see how a similar controller would install in a 2013 Toyota Tundra like yours check out the install video I attached.

expert reply by: Jameson C