Install Curt Front Mount Trailer Hitch Receiver, # 31108, on 03 GMC 2500 Yukon XL with skid plates
Question:
Can this be mounted if I have the optional from GMC at time vehicle ordered skid plates installed? Does the front air dam need to be cut?
asked by: Michael B
Expert Reply:
On the Curt Front Mount Trailer Hitch Receiver, # 31108, there is minor fascia trim required when installing on 2003 GMC 2500 Yukon XL. As far as the fitment on your vehicle with the skid plates istalled, I checked with the supplier (Curt), they said they have not heard of any problems of them fitting with factory skid plates, but if the skid plates were a dealer installed item, which is an aftermarket item, they would not know because they do not test their fitments against aftermarket products.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Class I Trailer Hitch for a 2021 Mercedes-Benz E-450
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Snowbear Plow Receiver Hitch vs Custom Mount
- Article: Carrying Bikes While Towing a 5th Wheel Camper Trailer
- Article: What Size Generator Do You Need to Run an RV Air Conditioner?
- Q&A: What is the E-Coat Base for Draw-Tite Hitch on 2004 Lincoln Town Car
- Q&A: Availability of Additional Go Power 200 Watt Solar Panels
- Q&A: Is Drilling Required to Install Curt or etrailer Trailer Hitch on 2024 Hyundai Palisade
- Q&A: How Level Does 12-Volt RV Refrigerator Need To Be?
- Q&A: Replacement Converter for 45 Amp Magnetek 6345
- Article: How to Measure for Trailer Hitch Drop
- Article: Measuring a Trailer Tire
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Stability Control for Heavy Duty Vehicles