Thread Size of the Wheel Cylinder part # BP17-030
Question:
would like to know the tread size for the hookup of the break line? Thanks
asked by: Eric K
0
Expert Reply:
The wheel cylinder part # BP17-030 that you referenced uses the standard thread sizes for trailer brake line kits, 3/8"-24.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Wheel Cylinder - 10" and 12" Single Serve LH
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- LH
- Wheel Cylinder
- 10 Inch
- 12 Inch
- Uni-Servo
- Redline
more information >
Continue Researching
- Q&A: Is Push Rod Included With Replacement Wheel Cylinder
- Q&A: How To Bleed Hydraulic Surge Brakes On Titan Model 60 Multi-Fit Brake Actuator
- Q&A: How to Determine Needed Pilot Diameter of Steel Dual Trailer Wheel
- Q&A: Replacement Hub & Drum For UFP HD-1377-10 & Hydraulic Brakes For Boat Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Instructions for Disassembling a 12,000 lb Bulldog Jack
- Q&A: Troubleshooting HydraStar Electric Over Hydraulic Actuator Not Building Pressure While Running
- Q&A: Electric Over Hydraulic Brakes Don't Work w/Brake Pedal on Newer GM Trucks w/OEM Brake Controller
- Article: 2023 Best Gifts for Auto Enthusiasts
- Article: 2023 Best Gifts for RVers & Campers
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Bleed Your Trailer Surge Brakes