How Close to Trailer Ramp Does Rack'em Double Barrel Trailer Tailgate Assist # RA-27C Need to Be
Question:
On your double barrel tailgate lift how close to the end of the top rail does it need to be? The gate latches on my trailer are on the very end of top rail on each side.
asked by: Mike R
0
Expert Reply:
When installing the Rack'em Double Barrel Trailer Tailgate Assist # RA-27C on a trailer you want the unit to be as close to the end of the rail as possible meaning that you want to be as close to the ramp as possible on the side rails as it can be without interfering with the latches or pins that secure the ramp in the upright position.
For more info check out the install video I attached as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Rack'Em Double Barrel Utility Trailer Tailgate Lift Assist w/ Chain - 200 lbs
- Lift Supports
- Trailer
- Tailgate Assist
- Steel
- RackEm
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Make Raising and Lowering a Heavy Trailer Ramp Easier
- Q&A: Ramp Assist Recommendation for a 60 lb Ramp
- Q&A: Alternate Mounting For Rackem Double Barrel tailgate Assist On Trailer With 3 Foot Sides
- Q&A: How Can Double Barrel Trailer Tailgate Assist # RA27C be Mounted on 24 inch Tall Trailer Side Rails
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Q&A: Recommended Gate/Ramp Assist and Hinge for Trailer Build
- Q&A: How to Adjust Assist Tension on the Gorilla Lift Tailgate Assist
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Measure a Trailer Axle
- Article: Slipper Spring Trailer Suspension System Review
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)