What Material is the Bulldog Replacement Plung Pin for Drop-Leg Jacks Made Of
Question:
I would like to know if this pin is corrosion resistant Do you possibly have a material spec or drawing for this pin please?
asked by: Tom F
0
Expert Reply:
I spoke with my contact at BullDog and plunger pin is a clear zinc coating over steel to help prevent corrosion. He did not have a drawing for it.
expert reply by:
Patrick B
0
Product Page this Question was Asked From
Replacement Drop-Leg Pin for Bulldog Heavy-Duty Square Jacks - 3/4" Diameter
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pins and Clips
- 3/4 Inch Plunger Pin
- Bulldog
more information >
Continue Researching
- Q&A: Replacement Master Cylinder for Titan 60ZX7000 Drum Brake Actuator
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: What Is The Torque Specifications On A 9/16 Inch Lug Nut
- Article: Most Popular Wheel Bearings
- Article: Best Tire Chains
- Q&A: Does Bargman 47-84-527 LED Trailer Taillight Have a Rubber Base
- Q&A: 1/2" Tall x 1/4" Wide Weather Stripping for a Featherlite Horse Trailer
- Q&A: Grease Seal Recommendation to Replace TCM 21334
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure a Trailer Axle
- Q&A: Replacing the Drop Leg Spring Loaded Pull Pin on a Bulldog 180 Series Square Jack
- Q&A: Replacement Seal Recommendation for Dexter 010-004-00
- Article: Trailer Jacks
- Article: 7 Common Questions Everyone Has About Trailer Tires