Roadmaster Base Plate # 1123-1 Hole Dimensions
Question:
If the holes are 1/2 inch diameter, how can the centers of the holes be 7/8 inch apart?? Currently working on a 1982 Toyota 4WD pickup with leaf springs.
asked by: Mark D
0
Expert Reply:
The two round base plate mounting holes closest to the front of the vehicle are 9/16 of an inch in diameter. The rear, oblong hole measures 1-1/2 inches long and 1/2 inch wide. The center to center distance between the two round holes is 1-3/8. This information came directly from my contact in the Engineering department at Roadmaster.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Roadmaster Crossbar-Style Base Plate Kit - Fixed Arms
- Base Plates
- Fixed Drawbars
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Base Plate Recommendations for a 1992 Toyota 4Runner
- Q&A: Replacement Crossbar Recommendation for a Falcon Tow Bar 5250
- Q&A: Parts Needed to Flat Tow 2016 Toyota 4Runner
- Q&A: Air Dam Trimming Required to Install Base Plate Kit on a 2015 Jeep Wrangler
- Article: Trailer Wiring Diagrams
- Q&A: Hitch Extender for 2.5 inch Hitch of 2020 Chevy Silverado 3500
- Q&A: 24 inch Hitch Extension Recommendation for Chevy Truck with 2-1/2 inch Trailer Hitch
- Q&A: Recommendation of a Hitch Extender for Motor Home to Flat Tow a Jeep Wrangler
- Article: Flat Towing Package for 2009-2012 Smart Fortwo
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Article: Roadmaster Vehicle Specific Base Plates