Dimensions of etrailer A-Frame Round Jack # TJA-5000S-B
Question:
I am interested in the TJA-5000S-B tongue jack. I need to know the measurement from the A plate to the top of the gear housing and the radius of the crank handle. The tailgate of our new truck when opened does not clear the jack handle of the travel trailer. Hoping that if the post above the A frame is shorter than the BAL jack post then the tailgate might clear the handle when opened. Can't use the top crank model due to proximity of propane tanks mounted adjacent to jack.
asked by: Igor
Expert Reply:
The height from the top of the mounting plate to the top of the housing is 15-inches. The radius of the crank handle is 8-inches from the shaft center point.
Product Page this Question was Asked From
Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- 16 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Smaller Trailer Tire Than 215/75R14 w/ 5 on 4-1/2" Bolt Pattern To FIt in Garage
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Jacks
- Q&A: Mounting Tab and Hole Size and Spacing of Ultra-Fab # UF48-979006 Scissor Jack
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: 2 inch Outer Diameter A-Frame Trailer Jack Recommendation
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Tire Sizing
- Q&A: Replacement Toggle Switch For Lippert Power Stance Trailer Jack
- Article: Double-Eye Trailer Suspension System Review
- Q&A: How to Measure the Angle of Trailer A Frame To Determine if a 50 Degree A Frame Coupler will Fit
- Q&A: Foot Plate that Fits Ram Jack # TJA-5000S-B
- Q&A: Availability of 5,000 lb Top Wind Trailer Jack with Grease Zerk Fitting