Where to Weld the etrailer Jack # TJD-5000 on a Trailer
Question:
Where can you weld the jack on so it is not distorted and will not work.
asked by: Charles H
0
Expert Reply:
Any where on the outside of the outer tube of the etrailer Jack part # TJD-5000 would work for welding the jack to your trailer. As long as you use a qualified welder there wouldn't be any problems with the jack warping.
I attached a picture that a customer sent us that shows a similar jack welded to a trailer.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Square Direct Weld Jack w/ Footplate - Drop Leg - Topwind - 29-1/4" Lift - 3,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 2001 - 3000 lbs
- Sidewind Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Continue Researching
- Q&A: Replacement For Dexter 072-100-00 4000 lb Leaf Spring
- Q&A: 16 Inch Trailer Wheels Rated for at Least 3,960 Pounds at 110 PSI
- Q&A: Will Linxup GPS Tracking Device Work With 4G Service
- Q&A: Cushioned Equalizer, U-Bolt Kit, and Leaf Springs for 2003 Keystone Cougar 276
- Q&A: Recommended Equalizers and Lift Kit For 7 x 12 Tandem Axle Cargo Trailer
- Q&A: 14 Inch Diameter Trailer Wheel with 5-on-4-1/2 Inch Bolt Pattern and 2-5/8 Pilot Diameter
- Q&A: Recommended Upgraded Equalizer for Trailer with 7,000 Lb Axles and 5-3/4 Long Equalizers
- Article: Trailer Lighting Requirements
- Article: Stability Control for Heavy Duty Vehicles
- Article: Most Popular Wheel Bearings
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Measuring a Trailer Tire
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Trailer Wiring Diagrams