Will B&W Biker Bar Tie Down System Fit a 2007 Victory Jackpot
Question:
Does it work on a 2007 victory jackpot
asked by: Pieter
0
Expert Reply:
The B&W Biker Bar # BWMC2301 is designed for Harley touring bikes but it is possible that it could work with other bikes. If the frame on your Victory (at the bottom of the bike) is 1-1/8 inches to 1-1/4 inches in diameter and the frame width is 10 to 14-1/2 inches apart then it would work.
expert reply by:
Michael H
0
Product Page this Question was Asked From
B&W Biker Bar Motorcycle Tie-Down System for Trailers - Harley-Davidson Touring
- Motorcycle Tie Down Straps
- Trailer
- Clamps
- Tie Down Anchors
- B and W
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Can You Replace A GE Air Conditioner Be Replaced With An Advent A/C?
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Solution for Atwood Surge Brake Coupler Needing Replacement Parts
- Q&A: How to Determine the Correct Replacement Bearings for a Trailer
- Q&A: Correct Replacement for Advent Analog Wall Thermostat ACTH1
- Article: Big Truck Big RV
- Q&A: Replacement Key Needed for Gorilla Guard Trailer Coupler Lock
- Q&A: Factory Brake Wiring Harness Location on 2012 Chevy Silverado
- Article: Pintle-Hitches
- Article: Best Ladder Racks
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Performance Chips and Modules
- Article: How to Install E-Track in 3 Easy Steps