Using Hitch Cover to Cover Gooseneck Ball Hole In Truck Bed
Question:
Will this cover work on the gooseneck hitch in the bed of my truck? It is a reversible ball, but I dont like to leave it in because they often get stolen.
asked by: Lynda
Expert Reply:
If your gooseneck ball uses a square shank that measures 2 inches by 2 inches, Hitch Cover # DT7010 you referenced might work for you, but typically the square shank would be larger than 2 inches square, so the cover you referred to would likely be too small.
Depending on the manufacturer of your hitch, there might be a purpose-built cover available. If you'd care to reply with the manufacturer and model of your hitch, I'd be happy to check on availability for you.
Product Page this Question was Asked From
Draw-Tite Logo Rubber Hitch Cover for 2" Trailer Hitches
- Hitch Covers
- Misc Covers
- Plain
- Rubber
- Fits 2 Inch Hitch
- Standard
- Square
- Draw-Tite
more information >
Continue Researching
- Q&A: Plug Or Cover For 4 Inch Hole In The Bed Of My 2010 Ford Super Duty Truck
- Q&A: Best 2024 Honda Passport Trailer Hitch and Wiring Setup
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Will Trailer Hitch Get in Way of Kick Sensors for 2020 Acura RDX Advanced Model
- Q&A: What Are the Differences Between the Kuat Piston Pro and Piston Pro X Bike Racks
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Trailer Hitch Receiver for 2016 Subaru Forester 2.0 XT
- Article: My Trailer Hitch Doesn't Fit
- Article: Rust Prevention
- Article: How to Choose a Hitch-Mounted Bike Rack
- Article: Trailer Hitch Receiver Sizes
- Article: Trailer Wiring Diagrams
- Article: Hitch Adapters and Extenders