1998 Acura Integra 4dr Hitch Recommendation
Question:
How much road clearance will I have after installing the hitch ? This car sits very low, close to the road. Why do you have the pin listed twice ?
asked by: Jeff
Expert Reply:
Yes, this Draw-Tite Sportframe Trailer Hitch Receiver # 24589 is confirmed to fit Acura Integras from 1994 to 2001 so it would work well on your 1998 Integra. I attached installation instructions for this product for you to check out also. The hitch opening will sit right under the rear bumper fascia of your vehicle so you would need to measure the current distance from the lowest portion of the rear fascia then subtract 2 inches and you will have about how much ground clearance you would have.
You may be interested in the following products to complete your towing setup:
Tow Ready Custom Fit Vehicle Wiring # 118336 (installation instructions and review video attached)
Sportframe Drawbar # 3593
1-7/8 in Ball # 19256
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
1-7/8" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 2,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 1-7/8 Inch Diameter Ball
- 1-9/16 Inch Shank Length
- 3/4 Inch Diameter Shank
- 2000 lbs GTW
- Class I
- Class II
- Draw-Tite
more information >
Draw-Tite Drawbar for 1-1/4" Hitch - 2-1/8" Rise, 2-3/4" Drop - 6-5/8" Long - 2K
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 3 Inch
- Rise - 2 Inch
- Fits 1-1/4 Inch Hitch
- 2000 lbs GTW
- Class I
- Draw-Tite
more information >