Diagram of a 10k Bulldog Landing Gear Jack for Gear Replacement
Question:
do you instructions for the repair I believe the nut is stripped but i want to take it apart before I order the parts
asked by: Henry M
1
Helpful Expert Reply:
To access the gears inside of the heavy-duty Bulldog jacks, like part # BD182415 to install the # BD500250 you simply remove the screws that are holding on the plate covering the top of the jack. Once that plate is removed, the gears, pins and handle should be exposed.
Check out the diagram I attached to see how all of the parts come apart and go back together.
expert reply by:
Jameson C
1
Products Referenced in This Question
Bulldog Square Jack - Drop Leg w/ Non-Spring Return - Sidewind - 26" Lift - 10,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Alloy Steel
- 9001 - 10000 lbs
- Landing Gear
- Sidewind Jack
- 26 Inch Lift
- Weld-On
- 1 Jack
- Bulldog
more information >
Continue Researching
- Search Results: rg06~070
- Shop: Gooseneck Hitch
- Shop: U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles - 7" Long U-Bolts
- Shop: Replacement Drop Leg with Foot for etrailer and Ram Square, Direct Weld Jacks - 7,000 lbs
- Shop: Trailer Wiring
- Search Results: fender
- Search Results: 10~36
- Search Results: oil cap
- Shop: Grease Seal - Double Lip - 2.250" ID - 3.376" OD - GS-2250DL
- Shop: Grease Seals 10-36 (pair)
- Shop: Replacement Rod and Nut for etrailer and Ram Square, Direct Weld Jacks - 12K
- Search Results: leaf spring
- Shop: 6-Leaf Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long
- Shop: Trailer Hitch
- Search Results: dx77xr
- Shop: U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles - 7-1/16" Long U-Bolts
- Search Results: st40rb
- Video: Bulldog Camper Jack - Landing Gear - BD182415 Review
- Q&A: How to Tell if a Bulldog 10K/12K Jack is a Single Speed or 2-Speed
- Q&A: Troubleshooting Bulldog Electric Landing Gear that Turns But Does Not Raise or Lower Jack
- Q&A: Troubleshooting Bulldog Powered A-Frame Jack that Does Not Want to Function
- Q&A: What is the Difference Between the 10-10 Grease Seals and the 10-36 Grease Seals
- Q&A: Instructions for Disassembling a 12,000 lb Bulldog Jack
- Q&A: Start Capacitor Solution for Dometic 15k BTU AC Unit
- Shop: Mud Flaps
- Shop: Brake Controller
- Video: Best 2012 Volkswagen Passat Trailer Wiring Options
- Video: Rebuilding a Bulldog 12000-lb Capacity Jack
- Q&A: Replacement Leaf Springs for a Vintage Camper
- Video: Review of Rhino Rack Replacement Male Component Support Hinge Batwing Awning - RR67TB
Tim
8/10/2020
I have 2-10k Jack's in tandem trailer was made in 1989 screw isn't replaceable can I get everything on top, bearings and gears