Installing 3rd Stoplight On 2015 Chevrolet Silverado 2500 Bed Cap
Question:
Can I use this to connect the lights on a 2015 Silverado 2500 pick up to the high stop light on a pickup cap.
asked by: Tom B
1
Helpful Expert Reply:
There should be a wire harness under the rear of your 2015 Chevrolet 2500 truck that you can tie into for the 3rd brake light on your cap. This wiring harness is normally found under the truck bed, usually above the spare tire. This would eliminate the need for a converter box like part # 118158.
You can use a circuit tester like part # PTW2993 to test the wires and find the wire that only shows current when the brake pedal is pressed.
expert reply by:
Jeffrey L
1
Products Referenced in This Question
Product Page this Question was Asked From
Vehicle to Vehicle Tail Light Converter
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 7 Round
- 7 Round
- Tow Ready
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Tow Bar Wiring Overview
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Q&A: Separating Out a Combined Brake Light and Turn Signal to Have Separate Turn Signals and Brake Lights
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Q&A: Getting Side Marker Lights to Function as Turn Signals and Running Lights
- Q&A: Grease to Oil Bath Trailer Hub Conversion Kit for 3500 Pound Axles
- Q&A: Choosing Between the Brake Buddy Select 3 and the Blue Ox Patriot Supplemental Braking System
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Separating Trailer Turn Signals and Brake Lights
- Q&A: Do I Need a Charge Line to Flat Tow a 2022 Ram 1500?
- Q&A: How To Determine Blue Ox Spring Bar Weight Capacity