Part Numbers: SS98GV,31053
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
82 x 14 Residential plow with thick rubber cutting edge self-adjusts up and down to smoothly clear a path on any terrain. Aluminum blade stays in straight-ahead position, and makes plowing your driveway as easy as pulling forward or backing out.
Features:
Specs:
Snowplow Installation
Front or rear mount? Versatility is the SnowSport LT's middle name.
Installation is quick and simple - just slide the included shank assembly into your 2" hitch receiver and secure with pin.
Once the plow frame is connected, attach the blade by lifting one end at a time onto the frame's holders. The lightweight aluminum blade construction makes lifting or adjusting an easy, one-person job. Secure the blade in either the transport or plowing position with the plow's snap pins. The low-profile design won't block your headlights, and the transport position is secure enough for highway travel.
If using with a rear-mount receiver, simply lower the blade to plow position and back up as usual. For a front-mounted plow blade, just drive forward with the blade in the plow position. The unique design takes the hassle out of plowing: This device has no hydraulics or complicated wiring. The push frame on the shank assembly allows the blade to move along the grade of the terrain for easier, more efficient plowing. The heavy-duty rubber cutting edge is effective yet turf friendly, collecting snow and squeegeeing slush without digging into the ground.
When you are ready to reverse your driving direction, the blade lies back, skimming over the surface of the ground until you change direction again to plow.
Handy blade markers extend vertically from the ends of the plow to help you see where you are plowing.
With the SnowSport LT, plowing snow is as easy as backing out of your driveway. Once you are finished plowing, simply lift the blade, refasten it in the transport position and head off for work or errands.
California residents: click here
Easily attach a variety of accessories to the front of your vehicle with this fully welded, corrosion-resistant trailer hitch receiver. Perfect for winches, spare tire carriers and more.
Features:
Specs:
At etrailer.com we're committed to the products we sell, and to our customers. Our experienced and knowledgeable staff are available via both phone and email to address your questions and concerns for the lifetime of your hitch. The technicians at etrailer perform hitch installations on a daily basis, making them a valuable resource for do-it-yourselfers. The one-on-one, personal service you'll receive comes straight from an expert in the towing and automotive field. We've installed it, we've wired it and we've towed with it, so whatever your question, we can answer it.
Average Customer Rating: 4.9 out of 5 stars (15 Customer Reviews)
82 x 14 Residential plow with thick rubber cutting edge self-adjusts up and down to smoothly clear a path on any terrain. Aluminum blade stays in straight-ahead position, and makes plowing your driveway as easy as pulling forward or backing out. Easily attach a variety of accessories to the front of your vehicle with this fully welded, corrosion-resistant trailer hitch receiver. Perfect for winches, spare tire carriers and more.Great item... but I did not try to mount it with the funky wire fishy things.... I just took the bumper off which is really not that hard to do or put back on at least on my '08 Econoline 250. And yes you do have to trim the plastic under part but that is no big deal either.
I'm really satisfied with this front hitch for my 2010 E350 XLT Super Duty. Installation is a bit more complicated than described. I was able to complete the installation in about an hour with the van on the ground. I opted to completely remove the front bumper which is only attached by four nuts. This give complete access to the inside of the frame rails so no fish wire required. This also makes trimming the upper valance much easier. Enlarging the front hole was pretty straight forward. I only had a 1/2 drill bit, but the bolts still dropped in without issue. The hitch does interfere with the factory mounted front license plate which I simply removed. After the hitch is bolted in place, the lower valance will no longer fit without trimming. The instructions provide no diagrams for this so I had to do my best with a Dremel tool. After a minor trim, the valance still required a bit of manhandling to reinstall. The end result is very nice and I look forward to many miles of use.
Very easy install and everything I needed was included. I didn't have a 17/32" drill bit so I used a 1/2" and it worked fine. I pulled the front bumper off, it's only 4 bolts. I ended up having to trim splash guard more than instructions said and used 2x self tappers (M10) for 2 rear ward screws.
I was a little surprised with the snow plow. I thought it was going to be hydraulic/electric. It does okay, going on flat and slight declines. Inclines not so good. I also. Bought a rear trailer hitch. Very pleased with it.
The hitch fit perfectly. The instructions showed it could be installed without taking of the front bumper, BUT it was VERY easy removing the bumper, which made it a snap installing the hitch. The instructions for cutting the plastic below the bumper was EXACT. The instructions for cutting the bottom plastic shield were wrong or misleading. But I made a few more cuts and it worked.
Wow! Excellent front hitch to launch my boat and built better than the one on the tail of my motorhome. I could launch a 40 footer with this thing and not worry about the weight! Delivered quickly and the best of all help to mount it. Highly recommend!!!
Lulin
10/18/2013
Any video of how to install this hitch , we have a E350 Van ford and want to carry a generator of about 135 lbs.
Install was made easy with the bolt fishing wires included for getting the bolts into the frame. I really like the position just below the bumper and coming through the air dam. I had to trim a small square out of the air dam, and a good amount from from the sides of the splash guard that's under the radiator. I understand some people just remove the splash guard altogether. That would be fine too but I like the more finished look. Works great for my bike carrier and as a recovery point. I also use it to run a small plow for clearing my driveway (I'm in MN). When not in use I keep one of those rubber plugs in to keep debris out. 2013 Ford E350 Super Duty XLT EB.
Hitch has been great one year in!
These guys are great! When I ever I've had an issue they are super professional and really help out. For example, I had a damaged item that I couldn't fix and reported it to etrailer. Next day the item is shipped and at my door shortly after. Awesome service! I always go here for the competitive price and exceptional service.
Well built I have ordered from etrailer before always great service and great products
No problems ordering it and it came qui ckly
Ask the Experts about this Snow Plow
Do you have a question about this Snow Plow?
Info for these parts were:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Loren
5/24/2020
I got stuck and there was NO way to get pulled out without it.