Filter by Brand
$17.24 - $17.24
Videos
for Boat Covers
Help Articles
for Boat Covers
Expert Answers
for Boat Covers
The TruXedo Boat Windshield Cover #TX38FR places the polypropylene against the windshield to protect it from scratches. If you were to put the fabric side against the windshield it could hold particles of dirt and debris. While in tow the cover…
view full answer...The DeeMaxx Disc Brake Kit #DE82FR comes with 2 Slip-on rotors, calipers and brackets for one axle. The slip on rotors are for a 6 on 5-1/2" idler hubs and the mounting brackets fit on a 5 bolt brake flange.
view full answer...The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…
view full answer...The diameter of the top plate on the #JSC-30 is 9 inches. This top plate is also the mounting plate as the bottom is what touches the ground. The holes on this plate are 7-7/8 inches apart measured across.
view full answer...The Saris Swing Away Hitch Extender for Bike Racks #SAR36VR has an overall capacity of 250lbs (rack and bikes) so it could technically accommodate two 85lb e-bikes as well as a rack, but the bike racks confirmed to be compatible with this extender…
view full answer...The main difference between the two covers that you mentioned is the application for the two. The Classic Accessories DryGuard Waterproof Boat Cover #CA20085 is designed for bass and fishing boats whereas the Classic Accessories Boat Cover…
view full answer...It looks like you have the BAKFlip MX4 for the 2013 Ford F-350 short bed, part #BAK48310. This tonneau cover does install inside the bed rails, so using the Thule TracRac SR Sliding Truck Bed Ladder Rack that is compatible with your truck, part…
view full answer...I attached a picture that shows the Torklift Camper Tie Down #TLF2021 installed on a truck with a set of running boards. If the running boards are cab length they'd be fine, but if they go from the wheel well to wheel well they would interfere as…
view full answer...To replace your 1,700 lb Shelby 5407B winch I recommend the Dutton-Lainson Single Speed Winch #DL14627 which is rated for 1,800 lbs. This winch features permanently lubricated bearings, high carbon steel gears, and a Zinc TUFFPLATE finish for…
view full answer...If you want to convert to a 5 on 5 bolt pattern the only option is for 3,500 lb axles. Assuming you have #L68149 inner and #L44649 outer bearings you could use #AKIHUB-550-35-EZ-K for an idler hub or #AKHD-550-35-EZ-K for a hub and drum assembly. If…
view full answer...I do not recommend going with 4,000 lb leaf springs on your boat trailer with a GVWR a touch less than 3,000 lbs. It will make the ride bouncier than need be, but a 3,500 lb spring should do well, assuming when your boat is on the capacity is…
view full answer...There are a few things that you will need to know in order to choose the right disc brake kit for your 2003 DHM boat trailer. I assume you have idler hubs and are replacing your brakes so you already have a 4-bolt brake mounting flange #4-35 as well…
view full answer...