It sounds like there's an issue with the wiring on the right hand side of your trailer. The Dexter Nev-R-Adjust Electric Trailer Brake Kit item # 23-468-469 should be equal adjusted at this point. I recommend checking all the wires and especially the connection to the brakes on that side. view full answer...
Yes, they do. The ones you were looking at, item # 23-468-469, are Dexter's Nev-R-Adjust brakes. This set of left and right hand assemblies are the top of the line option for your 2015 R-Pod 179 trailer. Once you install them and they get broken in you will never have to mess with them again.
If you are wanting the most affordable option, then I would go with the etrailer Electric Trailer Brake Kit item # AKEBRK-35. This is still a great set of brakes they just won't have the self adjusting... view full answer...
Basically you'd need a little over 10 amps of power at any given point based on the wattage of the accessories you mentioned so the 30 amp transfer switch part # 34264403 would easily work really well since it has about 3 times the amperage requirement. This would be a really solid choice that would work well so I recommend it for you! We also don't have anything lower amperage either. view full answer...
I have attached a picture with the dimensions drawn inside for the Replacement Tray for Stromberg Carlson Trailer Tray Cargo Carrier item # 7605-101P. It weighs 18 lbs and has a 300 lbs capacity. view full answer...
The two flanges are essentially the same thing but made by two different companies so either the # 34466V13B or the # T1009 would work great. view full answer...
The Classic Accessories PolyPro # CA80200 you were looking at is the best option we have for your 1958 Shasta AirFlyte that has a 14' body, but since this cover fits up to a 17'7" body you're going to have a little slack that you'll need to secure.
The next closest cover only goes up to 13'7" you'll just need to use the larger cover. view full answer...
For your 2012 Forest River R-Pod 177 the correct bearing kit is item # BK2-100. This kit is for a Lippert 4,400 lbs axle and includes inner bearing item # L68149, inner race item # L68111, outer bearing item # L44649, outer race item # L44610, grease seal item # 58846, and a cotter pin and a tang washer. You will need two of these per axle.
You will also want to get some LMX Red Grease item # L11390 to repack your bearings. If you need a grease gun you will want to use itemĀ # L30200 and... view full answer...
The distance between the brackets is 3" on the Scissor Stabilizer Jack item # TJSC-24.
I have linked a review video and a diagram with all of the mounting hole dimensions below. view full answer...
You will be able to easily remove the Thule HideAway Awning # TH490011 from the mounting brackets that come with the direct mounting kit, but it should be noted that this awning only sticks out 3-1/2" from the side of your R-Pod trailer. I've attached a picture that shows in the instructions for the HideAway and how it mounts to the mounting plates that attach to your trailer, but it does mount and come off fairly easily. view full answer...
Since Dexstar Steel Mini Mod Trailer Wheel # AM20746 has a zero offset the backspacing would be half the overall width of the wheel which on a 16 x 6 wheel is about 7 inches. That would make the backspacing 3-1/2 inches. view full answer...