For Curt Euro style ball mount # C45562, it measure 3-1/8 inches from the top of the shank to the beginning of the vertical curve that leads up to the ball. To the bottom of the ball is just over another 2 inches so it is about 5-3/8 inches to the bottom of the ball measuring from the top of the shank. I have included a picture showing the measurements. view full answer...
The Kenda 5.30-12 Bias Trailer Tire with 12" Galvanized Wheel # AM30750 that you referenced has a maximum speed rating of 65 mph, but for a similar wheel and tire with a higher speed rating we have the Taskmaster Radial Trailer Tire with White Spoke Wheel # TA78RR which is rated for up to 81 mph.
I attached review videos for both wheel/tires for you to check out as well. view full answer...
The tire sizes you mention are considered to be obsolete sizes. The 8.25-15 tire would have an 8-1/4 inch width and a diameter around 28-1/2 inches. The 7.75-15 tire would be around 7-3/4 inches wide with an approximate diameter of 27-3/4 inches.
The closest modern tire size to the 8.25-15 would be a ST225/75-15, available in bias ply load range D as part # AM1ST96, or in radial load range D as part # AM10256 or load range C as part # AM10251. A ST225/75-15 would be about the same diameter... view full answer...
The collapsed height of the TorkLift GlowStep Stow N' Go Scissor Steps # TLA7833 that you referenced is 12-1/2 inches. The approximate weight is then 55 lbs. view full answer...
I spoke with my contact at WeatherTech and got some overall dimensions of the All-Weather Front Floor Mats, # WTW11. The Driver side is 17 inches by 25 inches and the passenger side is 15 inches by 26 inches.
We also have these mats in gray, # WTW11GR, and tan, # WTW11TN. view full answer...
The Titan Zinc-Plated Straight-Tongue Coupler, part # T4853100 is designed to fit a 3 inch wide channel tongue on your trailer.
This entire coupler is rated for 21,000 lbs, not just one component. I called my contact at Titan and they told me that this coupler is SAE J864 certified, which is the certification number for 21,000 lb couplers. I have attached a link to a product review video you can check out. view full answer...
The M1 measurement for the Fulton trailer fender # F008573 is 28 inches. This measurement is the space between the inside edges of the mounting slots on the fender. I have included a picture showing the measurement on the actual fender. view full answer...
I went out to the warehouse to measure the length of the arms when extended for the JT's Strong Arm Jack Stabilizer Kit # LC191023. From the center of the hole on one end to the center of the hole on the other end it measures 46 inches extended. When retracted it is 26 inches. view full answer...
Good news! I was able to go out to our warehouse and measure the Curt Hitch # 13407.
I have attached an image to this page for your viewing convenience.
The Curt # 13407 is the confirmed fit for the 2004 Ford Explorer Sport Trac. This Curt Hitch # 13407 will even fit the Trac models that have a factory installed hitch.
The wiring harness I recommend for your vehicle is the Draw-Tite # 18252 because it comes with a handy tester to help identify which signal is coming from which wire... view full answer...
You measured the drop correctly. It would be from the center of the axle to the center of the spindle. That dimension would be the drop. See picture I attached. view full answer...