I checked with Curt and for your 2018 BWM X3 the part # C13387 is a confirmed fit and they state that the hands free liftgate will still work once installed. You'll just have to kick to either side of the hitch opening or make a wider movement with your foot. Whats really great about this hitch is that only the hitch tube hangs below the rear bumper so you get a more hidden hitch with better ground clearance. view full answer...
The rubber inside the Equa-Flex Cushioned Equalizers part # LC314336 is not replaceable, you'll have to replace the entire equalizer if yours are worn. It's hard to say about lifetime expectancy as this will vary from trailer to trailer and climate to climate. If you feel yours wore out too soon, make sure you are not overloading the trailer and that everything else like the leaf springs are in proper working order. view full answer...
The bearings in trailer hubs are measured to very precise dimensions, to the nearest thousandth of an inch, such as 1.234-inches. To find a suitable replacement hub to fit on your existing trailer spindles either the bearing part numbers or these precise measurements are needed to ensure you select a hub that fits on the spindles. The new hub must use the same bearings as the original.
If you refer to the linked photo you'll see how these part numbers typically appear on bearings. If these... view full answer...
There are a few things you can do to add brakes to your popup camper;
1. You can have the Brake Mounting Flange # 4-35 welded onto your current axle by a professional.
2. You can use the Timbre Axle-Less All-In-One Kit # A35RS545E which uses a different suspension system but comes with the brakes and hub/drums.
3. You can purchase a standard axle through a trailer shop that can custom order them.
I personally like the Timbren kit since it comes with everything you need plus it gives... view full answer...
The Sear cargo boxes were made for them by Thule. Although the original mounting kits are no longer available it is easy enough to adapt another u-bolt mounting kit to work well on this rooftop cargo box. It really just depends on the type of roof rack and the dimensions of that rack's two crossbars.
The kit # TH05603 that you referenced includes u-bolts that fit bars up to 3-3/4-inches wide and 1-3/4-inches tall. If your roof bars are within these dimensions then this kit is the best... view full answer...
Go To Results