If you said you need a 7-way trailer connector for your camper you can do a quick check to see if a 7-way is needed on your Jeep. Check the drums on the trailer to see if it has brakes.
If you need a 7-way because the trailer has brakes installed there are a couple things you will need. First you will need part # ETBC7. This attaches to the 4-way on your Jeep and attaching the other wires as shown in the attached drawing gives you a 4-way and a 7-way connector on your Jeep. If you do... view full answer...
The 2017 Jeep Renegade isn't capable of being flat towed. 4WD vehicles must be trailer towed, and FWD vehicles may be dolly towed, according to the owner's manual.
The Demco Kar Kaddy SS you'd looked at, part # DM9713045 is what I'd recommend. Many RV parks are pretty tight on the space, with little room for a tow dolly and a motorhome along with the towed vehicle, but the Kar Kaddy SS has a foldable ramp and tongue so it takes up very little space. This also comes in handy back home,... view full answer...
I can't provide an exact figure as we haven't yet had the opportunity to install the hitch. However, when installed the top of the receiver tube is directly under the bumper fascia. If you measure downward from the bumper fascia about 2-3/4 inches, you'll be right where the bottom of the receiver tube will be.
In other words, measure down from the underside of the bumper fascia at the rear of the vehicle until you hit the ground. Subtract 2-3/4 inches from this figure, and you'll have... view full answer...
Go To Results