Expert Answers about Mitsubishi Raider

• Will the Bedliner Need to Be Removed for PAL3600 Installation for 2006 Mitsubishi Raider
• You will need to be able to access the three bolts on the inside of the tailgate that secure the handle to the tailgate. If you have a slide-in bedliner you will need to temporarily remove it to do this. If its a spray-on liner and you can access the bolts fine then you would obviously not need to remove the liner.
  view full answer...


• Wiring a 4-Way connector on a 2006 Mitsubishi Raider
• The taillight wiring colors for your truck could be any color, manufacturers change wiring colors for many different reasons and often within the same model year. To determine the correct wires to use on your vehicle you will need to use a circuit tester, item # PTW2993 if needed, and test the wires behind the vehicle tail lights. On the driver's side you should be able to find a wire that carries the left turn/brake signal and a wire that carries the running light circuit. Connect the...
  view full answer...


• Can 2008 Mitsubishi Raider 2WD be Flat Towed with Driveshaft Disconnect
• If you have a rear driveshaft disconnect on your 2008 Mitsubishi Raider 2WD it can be flat towed with all 4 wheels on the ground. You could use the base plate kit part # 52276-1 that you referenced. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and supplemental braking to flat tow your vehicle. The most popular compatible tow bar is the Falcon All Terain, # RM-522. This has non-binding arms which makes the setup very easy to connect/disconnect. For...
  view full answer...