The Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part # HM11141395 is a confirmed fit for a Buick Lucerne from 2006 - 2011, therefore it does indeed fit your 2010. If you need any other parts to start towing with your 2010 Buick Lucerne such as a trailer hitch and ball mount/hitch ball, check out the list I have created for you below.
Curt Trailer Hitch Receiver part # C12022
Curt Drawbar for 1-1/4" Hitches part # C45520
Curt Hitch Pin and Clip part... view full answer...
The Super and Special are trim and packages that the 2008 Buick Lucerne could come with. The CXL Special Edition will have a chrome grille and chrome clad 17 inch wheels and a badge on the trunk that indicates it is a Special model. The Super can be identified by a rear spoiler. If you have a Special or Super model, hitch # 36502 will fit.
For a different model 2008 Buick Lucerne the comparable Draw-Tite hitch is # 36309. I have included a link to the installation instructions and a video... view full answer...
I am not sure what you mean by design but I have listed the parts below that you would need to set your 2006 Lucerne up to tow a trailer or use an accessory like a bike rack or cargo carrier. I have also linked an installation video and picture to show you what this hitch looks like installed. If you're not looking for a hitch and wiring harness then go ahead and email me back with a more specific description of what you mean by design.
Draw-Tite Trailer Hitch Receiver item # 36309. This... view full answer...
The tan WeatherTech Front Auto Floor Mats that will fit your 2007 Buick Lucerne is part # WT453081. The WeatherTech floor mats, # WT452681, that you referenced are designed for the Buick Lacrosse and will not fit your vehicle.
We also carry the WeatherTech floor mats for the second row and cargo area as well. For the second row of seats you will want to look at part # WT453082 and for the rear cargo area part # WT40463. All of the floor mats that I referenced were designed to fit your vehicle. view full answer...
For your 2006 Buick Lucurne, there are a few trailer hitch options. All of the available hitches are custom fit and compatible with all models and wheel sizes of your vehicle. I recommend the Draw-Tite Class II # 36309 as its install time is a bit shorter than the others.
I have included an installation video on a 2006 Buick Lucerne for you to check out. view full answer...
Yes, the 7-Pole Rubber Socket Boot, # PK11761, works with 3 of the Pollak heavy duty wiring sockets that we carry. You can use it with part # PK11720 that you mentioned and it can also be used with part # PK12801 and # PK11851.
The hole in the back of the boot is just under 7/16 inch and measures .425 with a dial caliper.
I produced a short video showing how the boot fits on each item for you. view full answer...
For the 50 inch Inno Square Crossbars # INB127, what you'll want to use is the 40 inch wind fairing, which is the following part number:
- Inno Fairing for Roof Racks # INA261
Really smart choice going with a wind fairing for square crossbars, as it will really help cut down the wind noise, particularly at higher speeds. view full answer...
Go To Results