Yes, that vehicle can be wired with a brake controller. The vehicle would not be pre-wired, so you would have to hardwire the controller. We have an installation instruction page that describes how to do this and I will provide a link to it below. As the help page mentions, you will need a brake controller, and 4Way Trailer harness, use T-One harness part # 118410, and a 7Way, like part # ETBC7. I will add a link to a page that has all our brake controllers. view full answer...
The wire gauge on the wire that is used to maintain a charge on your pop-up trailer would be 10 gauge, like # 10-1-1. The circuit breaker that is recommended is a 40 amp circuit breaker, part # PK54540.
This will allow you to maintain a charge on your trailer battery, it will not charge the battery from a discharged state.
To be able to fully charge the trailer battery from a discharged state you would have to use the NOCO Genius Mini # 329-GENIUS5. This charger can be used to fully... view full answer...
The best way to route the power wire from the Tow Ready Custom Fit Vehicle Wiring # 118410 would be to avoid any areas that might pinch or melt the wire. So basically try to avoid moving suspension components and hot exhaust pipes. Usually down a frame rail works best, but every vehicle is different and will require a little bit of improvisation. I attached an FAQ article on how to route power wires from converters boxes also. view full answer...
According to our friends at Firestone, drilling the hole in the control arm will not weaken or otherwise damage the vehicle.
The hole is absolutely necessary to provide access for the air line to connect to the bottom of the Coil Rite air spring. view full answer...
Yes, the T-One Wiring Harness, # 118410, will work if the factory wiring harness on your vehicle does not work. You can remove the factory wiring harness or tie it off underneath the vehicle.
The T-One wiring harness uses different connection points than the factory wiring harness. The T-One harness will plug into the tail light wires attached to the tail light assembly. I have included installation instructions and a demonstration video for you to check out. The vehicle in the video... view full answer...